Add page 5 to Favourites. Earlier supplied Recoil springs and tubes can certainly remain in use without problem. Except for the following listed components, all other components are interchangeable with the GLOCK Add page 6 to Favourites. Add page 7 to Favourites. All the safety or safety release devices function automatically. If the weapon is allowed to drop, or if the trigger is subject to an off centre, lateral pressure, it is still impossible for a shot to be fired.
This safety can only be released by the trigger being pulled by the trigger finger. This situation offers maximum possible firing readiness combined with maximum safety for the user. This safety is only released when the trigger is pulled back.
There is no possibility in this position of the firing pin being released. The rear sight is adjustable horizontally by displacement, while, for height adjustment. The magazine is filled by each individual round being pushed into the magazine from the front, with the base of the round being pressed down first against the pressure of the magazine spring. If using the factory supplied loading support, slip support over the magazine and place magazine on a solid surface. Hold loading support firmly and place thumb on top of loading device: Press down loading device against tension of magazine spring and, while keeping support down, insert a round as far as possible.
While pressing round downwards, slide support upwards release magazine spring and the round will slide into its rest. Repeat operation for subsequent rounds. Introduce or insert the magazine into the magazine shaft until the magazine catch engages fully. Add page 8 to Favourites. Pull back the slide with free hand, and allow it to spring forwards into the final position.
The trigger finger of the shooting hand remains outside the trigger guard. The weapon is now secured and ready to fire. After the last round has been fired, the slide remains open. Remove the empty magazine from the weapon by pushing the magazine catch Insert a new magazine and then either push the slide stop lever 27 downwards see photo , or pull the slide slightly backwards and allow it to spring forwards. The weapon is now again secured and ready to fire.
Remove the magazine see photo. Pull slide 1 back to eject the round which is in the barrel 2. Check to ensure that there is no round in the barrel 4. Allow the slide to spring forwards and pull the trigger into the full pulled position.
For maintaining and cleaning the weapon, it is recommended that the cleaning equipment provided as part of the accessories be used, together with the cleaning wadding and special gun greases and oils available from specialist dealers.
The GLOCK pistols are stripped into the main component parts in the following order: — removing the magazine — checking safety ensuring there is no round in the barrel — pulling trigger right back — removing barrel from slide. Before the slide and the receiver are dismantled any further, attention is drawn to the safety and guarantee conditions. Add page 9 to Favourites. Removal of the slide see photo is carried out as follows: — Grasp the pistol in the right or left hand in such a way that four fingers rest over the slide and the thumb rests on the rear side of the receiver.
If the slide is drawn back too far more than 3mm , the trigger will move to the foremost forward position. The slide will then not separate from the receiver Do not use force.
The trigger must first be pulled all the way back. Removal of the barrel see photo is carried out as follows: — Push the recoil spring assembly 3 somewhat forwards with the thumb and raise it — Take the recoil spring assembly out of the slide see photo 4.
Any change to the basic construction of the weapon, in particular by the circumvention of the safety devices, is strictly prohibited for safety reasons, and precludes the use of the weapon. The following actions are not permitted on the weapon since they could lead to damage: — With the weapon unloaded the trigger 26 shall not be manually brought into the foremost position and actuated. E-mail address.
Remember login. Login or create new account. Add to Favourites. Download as PDF. Overview View all the pages Comments. Page 1. Until the magazine is removed and you have inspected the chamber and complete the unloading procedures as presented on page 21, the firearm must be considered to be loaded and capable of being fired. Never aim at persons when handling the weapon. To reduce the As the trigger is All the safety or safety release devices function automatically.
If the weapon is allowed to drop, or if the trigger is subject to an off centre, lateral pressure, it is still impossible for a shot to be fired.
0コメント